top of page

ROBOTICS · AUTOMATED CELLS · END-OF-ARM TOOLING

Overmolding and cable assemblies for robotics

Cables that follow your robot cycle after cycle without breaking at the connector, and sensors sealed without a housing — made in Canada, with no minimum order.

Robot arm in a production cell, with cables and sensors routed to a cable tray

PROTOTYPES

No minimum order

TOOLING

Low-cost molds

HARNESSES

Per IPC/WHMA-A-620

MANUFACTURING

In Canada

01

Your requirements, our commitments

Our cables and sensors keep up with your robot in production, not just at commissioning. Four commitments guide every part we ship:

Flex life

A cable exit that absorbs the repeated motion of the arm and tool.

Repeatability

The same strain relief, molded identically on every part.

Compact packaging

Sealed sensors with no housing, where the gripper leaves little room.

Fast iteration

Prototypes at the pace of your engineering, without waiting on an offshore supplier.

02

How Fillio solves it

Overmolded cable exits

A molded taper spreads the bend over a length of cable instead of concentrating it at the connector exit, with identical strain relief on every part.

Overmolded sensors

The PCB is encapsulated directly, no housing needed — smaller, sealed (IP67/IP68 depending on design) and impact-resistant.

Custom wire harnesses

Cut, crimped, labelled and 100% tested to IPC/WHMA-A-620, ready to plug into the cell.

Prototypes and fixtures

Low-cost tooling and no minimum order — a single part if that is what validation needs; 3D-printed fixtures and test parts when useful.

Collaborative robot picking an overmolded flat-cable assembly from a bin in a workshop

03 — END-OF-ARM TOOLING AND COBOTS

At the end of the arm, every millimetre counts.

A gripper or end-of-arm tool must be compact, light and sealed, with a cable that follows every movement.

—

Protects tool sensors from impact, dust and moisture, without adding a housing.

—

Reinforces the tool cable exit, where wrist rotation makes it bend.

—

Works with the M8 and M12 connectors common in automation.

04 — AUTOMATED CELLS

In a cell, one failed cable stops the line.

Robots, conveyors, sensors and actuators share the same wiring. Every reliable connection is one less production stop.

—

Harnesses 100% tested and labelled, ready to install in the cell.

—

Overmolded sensors and connectors that stand up to vibration, dust and moisture.

—

From first prototype to production, under one roof in Canada.

Automated cell with a robot, conveyor and wired sensors, cables routed through overhead cable trays

05

Standards and environments

REQUIREMENT

WHAT FILLIO APPLIES

Harness workmanship

Procedures per IPC/WHMA-A-620, 100% tested

Sensor sealing

IP67 or IP68, depending on geometry and material

Materials

UL94-rated polymers, RoHS-compliant components

Connectors

M8, M12, Deutsch and industrial circulars

Environments

Repeated flexing, vibration, shock, dust and moisture

06 — OUR CUSTOMERS

Trusted by

Local robotics manufacturers that rely on us to protect and wire their products.

Robotiq

Try it on your robot.

Send us the cable or sensor that keeps giving you trouble: we'll propose a fix and a first prototype lot in whatever quantity you need.

bottom of page