top of page

MEDICAL DEVICES · WEARABLE HEALTH TECH · LAB EQUIPMENT

Overmolding and cable assemblies for medical technology

From the first prototype to production: your medical devices and equipment overmolded and assembled in Canada, with the same quality at every stage.

Gloved hand holding an intraoral camera with an overmolded grip in a dental clinic

PROTOTYPES

No minimum order

TOOLING

Low-cost molds

SEALING

IP67/IP68 depending on design

MANUFACTURING

In Canada

01

Your requirements, our commitments

A medical product often changes between versions, and every version has to be as well built as the final one. Four commitments guide every part we deliver:

Sealing

Electronics sealed as a single block, with no gasket or screw for moisture to get through.

Compact size

A part that follows the shape of your product, with no enclosure to add.

Reliable cables

Cable exits that withstand flexing and pull-out, handling after handling.

Fast iteration

We modify the mold between versions, without starting over or paying for a whole new tool.

02

How Fillio delivers

Low-pressure overmolding

Electronics are encapsulated in a heat-molded resin, with no voids and the same finish on every part. An alternative to hand-poured epoxy.

Cable assemblies and harnesses

Built and 100% tested to IPC/WHMA-A-620.

Mechanical design

Geometry and mold adapted to your product, at low tooling cost.

From prototype to production

No minimum order — a single part to validate, then production at the volume you need. Traceability per part or per lot on request.

Overmolded health sensor worn on the wrist, resting on a clinic office table

03 — WEARABLE AND CONNECTED HEALTH DEVICES

A sensor worn all day long.

Monitors and sensors worn on the wrist, on the chest or built into clothing have to stay small, light and sealed, and survive everyday knocks.

—

Sealed electronics with no enclosure and rounded shapes.

—

Cable or connector overmolded directly onto the sensor.

—

The same part from one prototype to the next, so your trials are comparable.

04 — DIAGNOSTIC AND LABORATORY EQUIPMENT

Reliable connections at the heart of the device.

Analyzers, imaging devices, probes and lab instruments rely on cables and sensors that get plugged and unplugged every day.

—

Documented, 100% tested harnesses.

—

Overmolded cable exits and junctions, reinforced against pull-out.

—

Traceability for every part produced.

Cable assembly with an overmolded Y-junction leading to two miniature medical cameras, on a lab bench
Overmolded control module of a powered wheelchair in the rain, hand on the joystick

05 — REHABILITATION AND MOBILITY AIDS

Electronics that go everywhere the patient goes.

Mobility aids, powered orthoses and rehabilitation devices get moved, bumped and splashed.

—

Overmolded controls and sensors, with no crevice or seam.

—

Cables that handle repeated flexing.

—

A geometry designed with you to fit your product.

06

Standards and environments

REQUIREMENT

WHAT FILLIO APPLIES

Sealing

IP67 or IP68, depending on geometry and material

Materials

UL94-rated polymers, RoHS-compliant components; material selected with you for the application

Harness workmanship

Procedures per IPC/WHMA-A-620, 100% tested

Electrical safety

Materials, insulation and cable exits selected to meet your device's IEC 60601-1 requirements

Traceability

Per part or per lot, on request

07 — OUR CLIENTS

“As a proud Quebec-based company, Fillio brings remarkable expertise to the table, from design through manufacturing.”

— Yvan Bissonnette, CEO, Controlab

From prototype to production, one partner.

Send us your board, your sensor or your 3D files: we'll propose an overmolded version, a first prototype batch, then production at your pace.

bottom of page